Starting Point for Elcon Clutch

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, and others.
H

hasgas

Well-Known Member
Messages
63
Reaction score
0
Location
SE Michigan
Hi all, Can anyone describe a good starting point for the Elcon during assembly? Full turns in, etc....on the grub screws
 
Wow, I don't believe that could have possibly been explained any more thoroughly, at all, ever, by anyone,..................
Thanks.
 
I did find 1 1/2 turns in is too much. I like 1 1 4/ turns in, you still are over 6000 rpm, but not wailing out at 8500-9000 rpm.
 
Back
Top