Steering servo help?

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, and others.
B

bhilly82

Well-Known Member
Messages
120
Reaction score
0
Location
Council Bluffs, Ia
Ok i am going to upgrade to the hs5755mg servo. I understand that it will not just go right in. What needs to be modifide to work. Is there a no mod plate to install the better servo? If anyone has pictures or links so i can see what needs to be done i would be very greatfull. I am sure i can just figure it out but i want to run it again this weekend so i want to make sure what i need now so i can get it ordered. Thanks Brian
 
the PA metal mount may fit that servo better, i used a 5755 hitec and a PA mount, only major mod was drilling out brackets mount holes on Rx box, it uses larger bolts. only other minor mod i had to do was use longer servo mount bolts because i also used the servo clamps and bolts were too short with the additional clamps, not a prob, hardware store you can get longer ones.
 
Back
Top