Steering servo question!

[waqr]

Hi!

I have recently bought a new Multiplex Rhino steering servo to my FG and I noticed that this servo is smaller than the Futaba I used earlier. Do I need som kind of adapter in order to make the smaller Rhino servo to fit?

Thanks!

 

[wagon]

yes mate u will. Or you could mod your one. Or better still, buy a new alloy one that the rhino fits snug into...

 

[waqr]

Ok, but what kind of adapter is it? Where can I find one?

 

[wagon]

Not sure..try this, nearly all fg bits here.. http://www.fg-modellsport-gmbh.de/F...nleitungen-layout_e/Webdatabase-Archiv_e.html

hope it helps... once youve found what u need just have a hunt.... Ebay normally good Hobbytech, pitstopshop,,,theres a few differnt places....

 

[sperera]

these also come with the kit in a small plastic bag, just 2 small peices of plastic really.

 

[Bigger the Better]

Yup it should of come with your kit. If you bought used it probably did not come with it.

You can see the piece here: http://www.davesmotors.com/s.nl/c.885035/n.1/it.A/id.1962/.f

It fills the gap in the front of the plate. Take the change now to NEED an alloy plate. :laugh:

 

[tizdaz]

I bought an alloy one..i too use an mpex rhino, but the ally one i bought didnt have the adapter so just used the one off my stock tray \o/