steering servo

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, and others.
R

rampage idiot

Senior Member
Messages
1,338
Reaction score
0
Location
Indiana Pa.
I need some opinions, I am running a rampage mt ver 3 with stock mt wheels and tires with dual steering servos in your opinion if I upgrade to a hitec 5755 do I need 2 or will one do the job. Thanks
 
both

i would do both, if u don't u may have binding issues, im not entirely sure on that,because i have a dunerunner, but the stock servos are junk and my throttle servo just went out..... too bad im broke guess ill have to wait
 
You could run two 5755's, or you could try one 5805. I personally don't like dual servo setups, too much of a hassle. I run one 5805 with the Futaba mount, and it gets the job done.
 
If you plan on running the MT tires a lot, I'd use 2 5755's....Once my HiTecs were setup, I have never touched them....they really hold the wheels straight and throw them around on any terrain.
 
Deluge I ordered a hitec 5805 do I have to do anything to the servo saver or any thing other than just remove second servo and linkage
 
When I installed mine, I had to adjust the servo saver because it was too loose. You'll probably have to adjust the EPA (Or dual rate, if you're using the stock radio). Other than that, you just remove the linkage and the servo.
 
Last edited by a moderator:
Deluge said:
You could run two 5755's, or you could try one 5805. I personally don't like dual servo setups, too much of a hassle. I run one 5805 with the Futaba mount, and it gets the job done.
Click to expand...
Will the 5805 fit on the xt? Is it stronger?
 
Cajun said:
so what is the difference between the 5755 and 5805? I am about to pull the trigger on buying the hitec 5755mg for my XT
Click to expand...
The 5805 is bigger than the 5755. Other than that, they're pretty much the same.

5755MG

Motor Type:3 Pole Ferrite

Bearing Type:Triple Ball Bearing

Speed (4.8V/6.0V):0.18 / 0.15

Torque oz./in. (4.8V/6.0V):278 / 347

Torque kg./cm. (4.8V/6.0V):20.0 / 25.0

Size in Inches:2.32 x 1.14 x 2.04

Size in Millimeters:58.93 x 28.96 x 51.82

Weight ounces:5.68

Weight grams:161.03

5805MG

Motor Type:3 Pole Ferrite

Bearing Type: Dual Ball Bearing

Speed (4.8V/6.0V):0.19 / 0.14

Torque oz./in. (4.8V/6.0V):275 / 343

Torque kg./cm. (4.8V/6.0V):19.8 / 24.7

Size in Inches:2.59 x 1.18 x 2.26

Size in Millimeters:65.79 x 29.97 x 57.40

Weight ounces:6.95

Weight grams:197.03
 
Back
Top