stuck grub screw!!!

[maddmike]

Ok so I am takin my mt apart to locktite the requured screws. I need 2 remove the grub screw holding the wheel adapers pin on the cvd. It's locktighted on to tight From factory . I tried adding a little heat but don't want the bearings to go from the heat from the propane. Any suggestions???? Very appreciative of any help! I am tryin to get wheel adapter off so i can red locktite grub screw on cvd.

 

[Deluge1]

Try heating it up with a soldering iron. Be careful with the red loctite on the CVD, some people have locked it up because they used too much.

 

[maddmike]

Alright I will have to try that

 

[TerraKill]

ive always found a torq bit and hammer drill and some heat to get mine out

 

[Ludabud]

yea i have the same problem with mine. once i get mine off its out the door with the cvd's....lol

 

[RampageHopUps]

Acetone will also work.

 

[Dncswann]

Wet the allen wrench and put sum powder ajax on the end, this will ensure a very tight fit in the screw head. Give it a whirl.