stuck screaw

[FH MT]

one of my screaws on my motor mounts is stuck i can't get it out i tryed putting WD40 on the theads were the screaw comes through the mount and it still didn't work
the head is not stripped it just keeps stripping my hex wrenches
what can i do to get it out
thanks

 

[Shiny]

Try WD40 and taping it with a hammer to get it lose.
Will did that with beiger bolts and it works.

 

[Bigger the Better]

If locktight was used you will need to heat it up to melt the locktight and loosen the bolt - Clean off the bolt and use blue next time.

 

[FH MT]

i didn't use locktight but it mite have some on it from factory and i had it out many times with out any problems
but thanks i will try those tips

 

[csp1971]

Bottom of the chassis? If it is use vice grips around the washer it sets in. I've had two stripped screws and both times was able to use the vice grips around the washer. Once I had the screw rotating with the washer, I stuck a flat head screwdriver under it and continued until it was out. Might work for you.

 

[FH MT]

ok thanks all try that