Take A Look... DogBone

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, and others.
it's funny nobody's mentioned it yet but I was told not long ago by a few dudes here that the MCD dogbones were a better up-grade,you would think so seeing that MCD is not a cheap knock-off
 
crazyfast said:
AWESOME!! I've had this issue of the set screw loosening on the front CVD's allowing that pin to move and catch the carrier bolt on all 3 of our XT's. Running the rear dogbones up front will fix that issue... at least on my dad's and brother's. I'm still not giving up on the 2wd lol
Click to expand...
I put Loctite on my set screws
 
carp boyz said:
it's funny nobody's mentioned it yet but I was told not long ago by a few dudes here that the MCD dogbones were a better up-grade,you would think so seeing that MCD is not a cheap knock-off
Click to expand...
They are definitely better, but they're hard to find. I got mine from LargeScaleRC, and it seems like they're always out of stock.

This is what you would need x 4:

MCD Rear drive shaft (Dog Bone) EVO2 & EVO3
 
does anyone know of a part number for the dogbone it self. im only finding a complete set on redcats website..

050009 is the complete set but i just need the bone...

i made a mistake today and bought 50034 but they are different design and shorter.. should have taken the busted part with me.. what a nub...

thanks
 
a7yqagy5.jpg


Is this what your looking for?
 
u know what nvm i cant use dogbones, im goona have to but the full set because im looking at it now its a whole different setup to get it into the piece that you mount yout tires onto. i don't think the 50035 would work. its long enough im sure of it but to get the set screw back in for the pin wont be possible.
 
T3X said:
u know what nvm i cant use dogbones, im goona have to but the full set because im looking at it now its a whole different setup to get it into the piece that you mount yout tires onto. i don't think the 50035 would work. its long enough im sure of it but to get the set screw back in for the pin wont be possible.
Click to expand...
Ok no problem, I know it sucks to buy a whole set when you just need one piece. Good luck with it.
 
You can use the dogbone 50035 also you will have to have the wheel axel also 50032 then you will get rid of the cva and just have dogbones and cups.
 
I just ordered dogbones and axles from ddm for my mt a week ago for front cause cvd broke dogbone part number is rc50034 and axles are rc50032
 
but 50034 are short thou... but with that on the 50032 will it be fitting snug with no play?
 
T3X said:
but 50034 are short thou... but with that on the 50032 will it be fitting snug with no play?
Click to expand...
they seem to fit fine even fully turned have no problems they are what replaces the cvds i found this out by another member and asked redcat racing i order thru ddm cause quick shipping and great people
 
Last edited by a moderator:
T3X said:
but 50034 are short thou... but with that on the 50032 will it be fitting snug with no play?
Click to expand...
yes the 133mm are little bit shorter and there is some play but it was the part # it was calling for
 
Last edited by a moderator:
Back
Top