The squish factor

[szaki75]

so here is how my squish band clearance was set to 0,53mm on a lathe:

did not grind the intake, just the exhaust port and exhaust side of the piston, and the clutch side transfers because they were lower than the flywheel side transfers.

 

[Seandonato73]

Wish I had access to a lath....

 

[szaki75]

a friend of mine made it who lives 2x 1hour drive away and always busy
so wasn’t easy for me either

no gasket could lower this head by 0,025” (it is just a rovan...)

 

[Seandonato73]

Yeah I used to work for a engine machine shop, had full run of the place after hours. don't miss the job, miss the equipment.