Throttle servo glitching after Killer Bee install

[jimmyjay]

Guys, I installed a killer Bee in my XT and am now the throttle servo is glitching bad. I think I have pretty much isolated it down interfearance on the wiring that goes from the killer bee over to the kill button. I have the EMI filter on the wiring.


Any suggestions? Is there a recommended wiring path to reduce EMI?

 

[Deluge1]

Which version is it? What channel is it hooked up to? Two channel systems, it hooks up to the steering channel. Three channel systems, it hooks up to the third channel or the steering channel. Also, are you running the stock failsafe along with the kill switch? Some people have had glitching issues with both installed.

 

[jimmyjay]

I have the kit that comes with kill button and ignition cable with optional LED and buzzer. It's a version 2 running on the steering channel. I have removed the stock failsafe.

Some more info...It is a Hitec-645 and there is no glitching at all until I fire up the motor, and it stops when I kill the motor.

 

[Deluge1]

Could be a bad spark plug, wire or coil. You could try and contact KillerRC and see what they say.

 

[rcnutctb]

I had that same problem, same servo. I am running the Spectrum radio DXR3 and I changed my throttle servo to a Hitec hs5955tg and steering to a hs5755mg both are prem. digital servos and that took care of the glitching.It may have something with the frame rate of your radio also but don't know for sure.