transmission plate screws?

[scooby61]

OK I went through this truck when I bought it and locked everything. No problems except the screws that go through the chassis to the Trans plate. I'm on my third set I've locked them with blue twice but if I use red the heads will probably strip if I ever need them out. Any suggestions? So far they hold fine for short runs but any time I burn 3/4 of a tank I end up missing 2 or all three. Could heat be the issue?

 

[Phill2]

OK I went through this truck when I bought it and locked everything. No problems except the screws that go through the chassis to the Trans plate. I'm on my third set I've locked them with blue twice but if I use red the heads will probably strip if I ever need them out. Any suggestions? So far they hold fine for short runs but any time I burn 3/4 of a tank I end up missing 2 or all three. Could heat be the issue?

I've got one with a stripped head just from using blue.

Can't understand why it wouldn't hold on yours.

 

[RampageHopUps]

Most likely your screw or thread aren't clean. Use alveoli to clean both. Then blue loctite and wait 24 hours to run.

 

[RampageHopUps]

Alcohol, lol

 

[scooby61]

I was wondering how alveoli would work lol. I used alcohol and applied liberal blue locker yesterday I'll give it a good run today and see.

 

[RampageHopUps]

It must be a real word, spell check fixed my bad spelling.