Tune Carburators after put5ing on a DDM Dominator pipe?

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, and others.
J

josegarcia8578

Well-Known Member
Messages
92
Reaction score
38
Location
San Diego, CA
Hi, I have a losi 5IVE 2.0 (zenoah g320rc) and I recently swapped the can for a DDM Dominator pipe. It took more pulls than normal to start but it started the idle was very low and it would poop off with breaks. I then simple increased idle with the idle screw and all good. Good high and low end (stock needle settings). Am I good to go? Or should I have messed with her LNS?

Also, why did it require me to increase idle with the new pipe? Vs the old can?
 
So do pipes lean out the engine?
I'm just curious because I had to adjust my idle screw to get the engine going and idling nicely
 
Last edited:
Back
Top