UberRC Ball Dogbones
- Thread starter BlakeyB
- Start date
This site may earn a commission from merchant affiliate
links, including eBay, Amazon, and others.
links, including eBay, Amazon, and others.
CSR260
Well-Known Member
- Messages
- 3,252
- Location
- LiVeRpO0L uK :P
look great but don't have a clue how they work?? do we buy new cups? or will they
work with the stock cups?
work with the stock cups?
atom3624
Well-Known Member
- Messages
- 8,284
- Location
- Cold, wet, windy St Helens, U.K.
Must be new cups - similar to FG ball drives.
Al.
Al.
MrFnisse
Well-Known Member
- Messages
- 163
- Location
- Malmö, Sweden
I don't see the point of their promotion video... you cant even see if the ball drive system is mounted since they have the boots on... kinda stupid. They also look kinda weak tbh ?
LOST IN MN
Well-Known Member
- Messages
- 297
BZM had a set of these at the RCX show... They are far from NOT being beefy. It will be interesting to see how they hold up. Only downside I see is the bearing flying everywhere when doing maintenance.
And yes the cups needed for this system come of the kit.
From their website:
This Ball Drive system comes complete with the following:
x2 9mm thick HD Ball Drive Dogbones with pre installed bearings ready for use.
x2 HD Ball Drive cups (Wheel end)
x2 HD Ball Drive cups (Diff end)
x4 Grub screws
x5 Spare Ball Bearings
And yes the cups needed for this system come of the kit.
From their website:
This Ball Drive system comes complete with the following:
x2 9mm thick HD Ball Drive Dogbones with pre installed bearings ready for use.
x2 HD Ball Drive cups (Wheel end)
x2 HD Ball Drive cups (Diff end)
x4 Grub screws
x5 Spare Ball Bearings