upgraded to belt drive

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, and others.
B

Bigboysrc

Well-Known Member
Messages
139
Reaction score
0
Ok so the new motor arrived and so did the needed parts for the belt drive and the bell part # 50029n the outer bearing on the gear mount will not fit the shaft. Does anyone know what size this is? I was under the assumption they were all the same size but thats what I get for assuming i guess
 
It's not the bearing my friend. The bearing is to sit on far section of the shaft before it steps up to the thicker section. Your gear plate is too short to support the bearing and longer shafts.
 
holly crap its always something! dang now another week long wait to try out this new motor grrrr
 
bigboysrctoys said:
so your saying the gear plate needs to be changed out also? part#?
Click to expand...
Yes, everything that has to do with the 4pin gear drive system is wrong for the belt drive. Part #050004 will work.
 
got all the shafts didnt realize the gear plate needed changed tho. o well learning experience I guess. just more money into this thing :)
 
yea hate the wait game especially now that this new motor is in and ready to be fired up! guess ill tear it down and powder coat some parts while I wait again.
 
bigboysrctoys said:
Ok so the new motor arrived and so did the needed parts for the belt drive and the bell part # 50029n the outer bearing on the gear mount will not fit the shaft. Does anyone know what size this is? I was under the assumption they were all the same size but thats what I get for assuming i guess
Click to expand...
It's the gear plate, dude. Bummer. Time to open up the wallet, again.
 
Back
Top