Vesla SBK slipper clutch pressure plates

[Kratonwatch]

Question about these pressure plates. Which way do they go? The instructions look like they are scalloped, which they are, and they face opposite each other, but my gut is telling me they all go the same way. Any info is appreciated

 

[smokinwheel]

As shown.

They are basically what is called a "Bellville Washer" designed so the two facing each other act as a spring.
The more you apply pressure when tightening the less slip you will have.

 

[Kratonwatch]

As shown.

They are basically what is called a "Bellville Washer" designed so the two facing each other act as a spring.
The more you apply pressure when tightening the less slip you will have.

Phew! So I did it correctly. Thank you so much

 

[jeepfreak1972]

Phew! So I did it correctly. Thank you so much

Correctly if the cupped sides face each other. Not nesting together like spoons.

 

[cmbscx10]

The picture of the manual is correct. Unfortunatly yours does not.

Same slipper but different kraken RC. Go to min 2. I watched all these before purchasing my first Kraken.

 

[Kratonwatch]

The picture of the manual is correct. Unfortunatly yours does not.

Same slipper but different kraken RC. Go to min 2. I watched all these before purchasing my first Kraken.

Huh. I’ll take it apart later to see where I went left. I swore I followed the directions to a T.

 

[smokinwheel]

Correctly if the cupped sides face each other. Not nesting together like spoons.

Yes , cup sides facing each other. Not like spoons. Good and simple explanation right there.

EDIT: Sorry guys , when I posted earlier I meant as shown in the manual and not the actual picture. Should have been a little clearer ,
Thanks jeepfreak for straightening out my poor explanation.

 

[Kratonwatch]

Thanks for all the info everyone. Mine is now set up properly

 

[jeepfreak1972]

Yes , cup sides facing each other. Not like spoons. Good and simple explanation right there.

EDIT: Sorry guys , when I posted earlier I meant as shown in the manual and not the actual picture. Should have been a little clearer ,
Thanks jeepfreak for straightening out my poor explanation.

No problem bud. That said, I knew what you were referring to. Lol

 

[Kratonwatch]

I checked the orientation 2-3 times and they’re on correctly they just look like they do. Maybe I over tightened the nut and flattened some out?

 

[Dreday]

Vraag over deze drukplaten. Welke kant gaan ze op? Volgens de instructies lijken ze gegolfd, wat ook zo is, en ze staan tegenover elkaar, maar mijn gevoel zegt me dat ze allemaal dezelfde kant op gaan. Alle informatie is welkom.


View attachment 94470View attachment 94471

Ik heb de onzin van de slipperclutch verwijderd.