Volcano S30

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, and others.
S

Starlet Dude

Junior Member
Messages
3
Reaction score
0
Location
Brbados
Just got my volcano S30 truck. Got it started a few times an it was pig rich. Started messing around with the rich/lean an idle screw lol then it wouldn't start at all lol. For the idle screw firstly...... can you tell me if i screw it all the way IN.... how many full or half turns would i have to come back out and the same goes for the idle screw. Hope someone can help me soon lol i suck at this
 
You might have better luck posting this in the Redcat Electric and Nitro Vehicles section. Most of the guys visiting this section are geared toward the 1/5 scale. I just checked the online manual for you and I didn't see the factory needle settings in there. Here's the link:


http://content.yudu.com/Library/A181sy/TornadoBBTornadoS30V/resources/index.htm?referrerUrl=http://www.yudu.com/item/details/57441/Tornado-BB---Tornado-S30---Volcano-SV---Volcano-MX---Volcano-S30---Volcano-T2-Manual


You may have to check with Redcat support to find the factory needle settings and tune from there.
 
where do i start throttle stop screw look down the carb the slide should be open 1mm then the high speed needle should be from closed open 3 full turns the low side should be closed now open 2 full turns also pull the glow plug and hook up the battery to it see if all the coils are red all the way to the top :D
 
racetruck said:
where do i start throttle stop screw look down the carb the slide should be open 1mm then the high speed needle should be from closed open 3 full turns the low side should be closed now open 2 full turns also pull the glow plug and hook up the battery to it see if all the coils are red all the way to the top :D
Click to expand...
Ahhhh nitros :) how I do not miss them.
 
Back
Top