Walbro Carburetor 101 schematics (with photos)

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, and others.
Grab the fitting tight and twist out the remaining tube. Run 10-32 tap into it and make sure to clean out all shavings that get inside of carb. Than use either a straight or 90 degree fitting on it. Make sure to use sealer when installing it. You can also get the factory replacement fitting too but most guys just thread it and put a fitting in.
 
Back
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.

I've Disabled AdBlock    No Thanks