Streetwise
Well-Known Member
- Messages
- 286
- Location
- Essex
So while i was stripping my MT down for a clean up, my standard elec box had quite a bit of water sitting in the bottom mg:
I genrally put everything in a plastic bags for this reason. I decided to change the box and fit a new on/off switch as its getting worn and hard to use.
I have a voltage regulator, Kill switch pcb and the reciever so space was tight in the standard box. Figured i would take pictures as i went.
Grommet for cable entry
Finished box complete with kill switch LED
The power switch is much easier to use and waterproof and sits on a gasket. The LED is super glued in and has silicone on the underside. The top also has a gasket.
That should keep em safe
I genrally put everything in a plastic bags for this reason. I decided to change the box and fit a new on/off switch as its getting worn and hard to use.
I have a voltage regulator, Kill switch pcb and the reciever so space was tight in the standard box. Figured i would take pictures as i went.
Grommet for cable entry
Finished box complete with kill switch LED
The power switch is much easier to use and waterproof and sits on a gasket. The LED is super glued in and has silicone on the underside. The top also has a gasket.
That should keep em safe