will this work for a engine

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, and others.
T

twinmill571

Junior Member
Messages
11
Reaction score
0
Location
AZ, Tonopah
http://www.davesmotors.com/s.nl/c.885035/n.1/it.A/id.4519/.f


and do you recommend there pipe or something else? Is anybody running a silencer on theirs? Thanks i think my engine is not going to last the guy rigged a k&N on it and I thought it was tight enough but i went bashing the other day and didn't notice it came off and after going threw some sand and dirt notice it was off not good but give me a excuse to put a bigger engine in it.
 
twinmill57 said:
http://www.davesmotors.com/s.nl/c.885035/n.1/it.A/id.4519/.f
and do you recommend there pipe or something else? Is anybody running a silencer on theirs? Thanks i think my engine is not going to last the guy rigged a k&N on it and I thought it was tight enough but i went bashing the other day and didn't notice it came off and after going threw some sand and dirt notice it was off not good but give me a excuse to put a bigger engine in it.
Click to expand...
Will work it`s a good engine, get the Dominator side pipe for it . I have the same motor and pipe on mine runs good.
 
Deluge said:
If you have the cash, go for a 4 bolt Zen.
Click to expand...
I concurr. 4 Bolt is the way to go. 2 bolt cylinders and crankcases are not even close to being gasket matched. You have to spend about 30 minutes on them with a dremel to get rid of the power loss associated with the parts not matching. 4 bolts are not perfectly matched either in 2 areas but for the most part it's close enough.
 
Deluge said:
That's the engine I run. You could get a JetPro side pipe with a silencer.
Click to expand...
I run the jetpro side pipe as well, haven't used my silencer as of yet, but it is kinda loud, lol, maybe I should try the silencer... Did you have any power loss with the silencer?
 
Back
Top