XT-B Truggy

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, and others.
D

Dreggsta

Senior Member
Messages
812
Reaction score
2
Location
Baton Rouge, LA
rcdad you asked where the pics were. it's not done yet but it's very close to being done & then i can start on mine which will be an xt w/the body lowered as far down til it touches the spark plug cage. it'll have the xb rear wing on it too. it'll get cut some but not sure yet in how bc my focus is on getting my son's xt-b done.


my son's & mine have: copper drive cup braces (6 total per vehicle), 1" velocity stacks, dt1 dual folw filter, tgn pre-airfilter, ddm pull start prefilter, alum gear plate, alum front chassis brace, alum front/rear shock towers, killer bee, voltwatch2, 7075rc front/rear hubs, xb rear wing, xq throttle/steering servos, ngk spark plug & fuel vent.
 
Last edited by a moderator:
huge-thumbs-up-smiley-emoticon.gif
Looks cool
 
Thanks guys. I wasn't sure what ya'll would think. I like creating my own variations. I haven't tuned the suspension yet but it will be set w/the chassis slightly higher than the arms at parallel w/the ground. i want the dog bones to be close to level.
 
Hey.. That looks pretty cool Dreggsta. Try 45wt oil for the shocks It will help sop up the terrain and supports level dogbones
 
I'd like to see it in action too. Almost done w/it so I can get mine done. The truggy is my son's. I want to get them prepped & ready before I run them.
 
Back
Top