thought i'd started a build thread for this, but must have been just in the pics thread ,
so anyways, miles wanted some info on a pcsc top hat spacer mod for using hostile spurs,
so am stickinit here cos the delboy baja is what i have the pcsc on
so basically its a baja with x2e a arms , some bonehead rc carbon, stock g320, fastpipe
some custom home made parts, unknown cage thats been modded to clear the i-rc big bore shocks etc etc,
so, pcsc,
top hat washer far right, and spacer washer for bearing etc,
top hat does away with the need for multiple washer shims and makes a much neater and stable job with the mod,
top hat fits inside the hostile spur and butts up against the bearing,
also does away with the need for the orange or purple spacer behind the pcsc as it sits against the layshaft/input shaft bearing as well,
top hat looks like this side on,
31.5mm outer diameter
12mm hole
7.8mm total thickness,
and the stubs are near enough 3mm each
so centre of top hat is 1.8mm thick,
i use a modified alloy gear cover, think its a 2 speed one and i bored the centre to clear the pcsc,
then also today while i was messin around with it i changed the outer beads from black hostile ones to orange ddm bite lock ones ,looks way better than the black i reckon,
and rewound the pull starter as well, not actually with the cord shown cos worked out that was too thick once i wound it on , used some thinner cord that i had in toobox
also its a used pull starter, not the new one that came with the g320, that got swapped to my g340 obr reed engine,
the g320 one had too short a cord and needed a couple extra turns on it,
couple o fresh pics taken today when cage was back on
so anyways, miles wanted some info on a pcsc top hat spacer mod for using hostile spurs,
so am stickinit here cos the delboy baja is what i have the pcsc on
so basically its a baja with x2e a arms , some bonehead rc carbon, stock g320, fastpipe
some custom home made parts, unknown cage thats been modded to clear the i-rc big bore shocks etc etc,
so, pcsc,
top hat washer far right, and spacer washer for bearing etc,
top hat does away with the need for multiple washer shims and makes a much neater and stable job with the mod,
top hat fits inside the hostile spur and butts up against the bearing,
also does away with the need for the orange or purple spacer behind the pcsc as it sits against the layshaft/input shaft bearing as well,
top hat looks like this side on,
31.5mm outer diameter
12mm hole
7.8mm total thickness,
and the stubs are near enough 3mm each
so centre of top hat is 1.8mm thick,
i use a modified alloy gear cover, think its a 2 speed one and i bored the centre to clear the pcsc,
then also today while i was messin around with it i changed the outer beads from black hostile ones to orange ddm bite lock ones ,looks way better than the black i reckon,
and rewound the pull starter as well, not actually with the cord shown cos worked out that was too thick once i wound it on , used some thinner cord that i had in toobox
also its a used pull starter, not the new one that came with the g320, that got swapped to my g340 obr reed engine,
the g320 one had too short a cord and needed a couple extra turns on it,
couple o fresh pics taken today when cage was back on
Last edited: