cy and a kingmotor engine

[stevemack]

ok im looking at a billet head kit from daves motors it says it fits cy 29cc will this fit my kingmotor engine

 

[Lan-Ed-Tul]

should if the KM is a 29cc engine

 

[stevemack]

its a 30.5 will that matter

 

[Lan-Ed-Tul]

dunno hopefully one of the other guys might know

 

[mrep32u]

Just chuck the km motor all together.

 

[Pollishman]

Just chuck the km motor all together.

No need to chuck the KM motor. Is the head you're looking at a 2 bolt head?

!

 

[handgrenade73]

It will bolt up to your KM if its 2 bolt. May have to change crank from 2mm stroker to 28mm unless head is cut for the 2mm. last option stack gaskets

 

[gary50]

it probably will fit but don't waste ya coin, put it towards a decent engine :w00t:

 

[chitown joe]

its a 30.5 will that matter

why are you wanting to change out?
is this what your looking at?
http://www.davesmotors.com/s.nl/c.885035/n.1/it.A/id.4749/.f

 

[hotrod45]

motors

zenoa at www.gizmotors.com he has the lowest prices on the internet

 

[stevemack]

no its the kit with the machined head and changable domes

 

[handgrenade73]

Your good to go cause those are made for the 2mm crank..Use the .020 gasket and you need to get the 35mm piston kit also

 

[stevemack]

its this one http://www.davesmotors.com/s.nl/c.885035/n.1/it.A/id.4752/.f

 

[handgrenade73]

its this one http://www.davesmotors.com/s.nl/c.885035/n.1/it.A/id.4752/.f

Didnt know everything was included..Yes it will fit

 

[stevemack]

im looking for style and performance

 

[chitown joe]

well for for $43 more you get the cy crankcase with bearings and pull your manifold,carb, pull start parts off the old engine, otherwise the km crankcase will be fine to use