Pic of your worst 1/5 scale carnage.
- Thread starter Gordo...
- Start date
This site may earn a commission from merchant affiliate
links, including eBay, Amazon, and others.
links, including eBay, Amazon, and others.
- Messages
- 19,475
- Reaction score
- 27,691
Once was turning around on road and hit the throttle instead of the breaks and bent my whole front end up
Another time I bit a big wheelie and flipped and broke the upper arm and servo saver (not too bad)
Another time I bit a big wheelie and flipped and broke the upper arm and servo saver (not too bad)
Z if you have it please post mine . Thank you.
MonsterAir
Lone Racer 🤠
I wish pictures were a thing back then but I've bent my Marder almost in half more than once lol. Hit a tree 40' in the air once on a bmx jump in the woods. I think that was the last time I attempted any type of big air 
Busted up a reed motor and almost every part on the rig.
Busted up a reed motor and almost every part on the rig.
- Messages
- 19,475
- Reaction score
- 27,691
Markcarr
Well-Known Member
I broke the front and rear bumper brackets ???
obr twin with a bent pipe on the right side, did this a few times in rolls and flips 
,
not sure whether this pic is the flat out end over end or the wedged under a fence one, which also resulted in actually bending a team chase cage,
where the pipe should be after straightening,
might have been the end over end one cos car has nightmare fronts on the rear after doing speed runs, (was trying to get lees rolling resistance for max speed)
,
edit, after looking at pics i think both pipes were bent after this crash, kinks in the headers etc,
another edit, plus busted cooling fan after pushing cage down into fan after a heavy roll,
,not sure whether this pic is the flat out end over end or the wedged under a fence one, which also resulted in actually bending a team chase cage
,where the pipe should be after straightening,
might have been the end over end one cos car has nightmare fronts on the rear after doing speed runs, (was trying to get lees rolling resistance for max speed)
,edit, after looking at pics i think both pipes were bent after this crash, kinks in the headers etc
,another edit, plus busted cooling fan after pushing cage down into fan after a heavy roll,
Last edited:
Not the worst ? but the most recent ?
Flipped the twin a bit hard?
Snapped a bonehead brace? holly foook?this ??was all from the same day?
Flipped the twin a bit hard?
Snapped a bonehead brace? holly foook?this ??was all from the same day?
- Messages
- 13,208
- Reaction score
- 22,962
And zed says you don't ride hard. Heck his would have fell right apart
Yip it was a big tumble ??
?
- Messages
- 19,475
- Reaction score
- 27,691
First time I've seen him go hard ? and hardly you feking idiot.
Markcarr
Well-Known Member
Got the same bent turnbuckle.Not the worst ? but the most recent ?
Flipped the twin a bit hard?
View attachment 68879View attachment 68880View attachment 68881
Snapped a bonehead brace? holly foook?this ??was all from the same day?
On a good note olimat has shipped