northwoodslivin
Active Member
- Messages
- 31
- Location
- St. Thomas, Ontario
Hey guy's
Well I've got an FG Marder, it's got a CY 29cc motor with a stuffed 2mm stroker crank, race ported,piston, dome and has one of those billet heads on it. The person that I got it from said this was all put on it over the winter and has had 1.5 tanks run through it.
Well today I finally got around to getting to play with it for a bit as I needed to get a battery setup for it. Took it around the backyard and up and down the drive way a few times, noticed there was oil/fuel mixture coming from the head, lovely I said... brought it inside and all 4 of the damn head bolts we're loose. Ok, so I tightened em all up in an X pattern and cleaned off the oily gas, went out after dinner, drove it for about 10 minutes but a little harder this time, drove it over to me and noticed the effin head was leaking again, its leaking where the actual billet connects to the cylinder.. wtf? I guess these billet heads are sht? Anything I can do to fix this?
Here is a picture. I take it that this is very bad and shouldn't run the engine until this is fixed....
Well I've got an FG Marder, it's got a CY 29cc motor with a stuffed 2mm stroker crank, race ported,piston, dome and has one of those billet heads on it. The person that I got it from said this was all put on it over the winter and has had 1.5 tanks run through it.
Well today I finally got around to getting to play with it for a bit as I needed to get a battery setup for it. Took it around the backyard and up and down the drive way a few times, noticed there was oil/fuel mixture coming from the head, lovely I said... brought it inside and all 4 of the damn head bolts we're loose. Ok, so I tightened em all up in an X pattern and cleaned off the oily gas, went out after dinner, drove it for about 10 minutes but a little harder this time, drove it over to me and noticed the effin head was leaking again, its leaking where the actual billet connects to the cylinder.. wtf? I guess these billet heads are sht? Anything I can do to fix this?
Here is a picture. I take it that this is very bad and shouldn't run the engine until this is fixed....
Last edited: