Dynamite Kill Switch with DX5PRO

[Edward3340]

I am trying to install a kill switch on my Rampage XT. The kill switch is not lighting up and when i set the aux switch to button H it’s still not working. Truck will not start unless i unplug the kill switch. I have a SR315 receiver. Please help

 

[Losi125]

It's probably faulty I had 2 of them that where bad call horizon hobbies they will help you out

 

[Edward3340]

Ok update, i plugged It in the steering port and light came on, when i plug It in the aux port i can’t get It to work. I volt tested the aux port and i get 6.5v. I feel like there is a setting in the remote i am not setting.

 

[Top Dead Center]

Did you bind the Rx with the kill switch installed?

 

[Edward3340]

I have a 3 channel receiver and i put It on the only aux port got no light, then i put It in bind mode and after It finished still no light

 

[-Dusty-]

Not really familiar with Spectrum but I read that you have to disable AVC to use the the killswitch. I Could be wrong though

 

[Edward3340]

Disabled that and anything else i don’t use already

 

[Top Dead Center]

Here is my step up with DX5R and Killer Bee.
Bind with frame rate @ 11ms
Channel Assign>Channel: AUX1> Input: -H-> Momentary: Inhibit
Full brake then bind.

If I remember correctly my kill switch didn't work when I bound the RX @ 5.5ms frame rate.

You may also have a bad switch as mentioned above.

Good luck and welcome to LSF

 

[Edward3340]

Thank you so much been trying to get this working for 2 days now. That worked. Again thank you

 

[Top Dead Center]

Right on. Now take it outside and wake up the neighborhood tonight.

 

[Edward3340]

Lol