Flaky Kill Switch

[djbuzzard]

This issue recently started - When I steer to right, the kill switch (Killer B v2) kicks in. It only happens when I steer in that direction. Once I steer left, the killswitch disengages and I'm able to start up again. I'm thinking my servos (Turnigy S8166M x2 setup on a Redcat MT) may be pulling too much amperage and tricking it to think the charge is low. I've tried two different batteries with the same results. Any ideas?

 

[WoodiE]

I think you're probably headed in the right direction but I'd reach out to @Killer RC and get his input just to be safe.

 

[djbuzzard]

Thanks, I'll be reaching out to him also. For some reason I couldn't access his website from my job.

 

[atom3624]

They may pull too much if they are straining - possibly check the end-point is set correctly for the side that cut's the kill switch.

Killer are always very helpful - drop them an e-mail.

Al.

 

[Paul G]

I had an issue like this was my throttle servo shorting out. Try different servos to see if you get the same results. Check wires also maybe when you steer something is binding up and putting a kink in the wire.



Sent from my iPhone using Tapatalk