Fullforce High Flow Fuel Kit Loose Fit Fix?!?

[DougStar]

Blocked the fuel cap hole? maybe I should change the breather?‍??

I have the snappy kit on my baja, the breather supplied with the kit leaked all over the place so i changed it for an rfx dirt bike one and all is good.
Also be sure to block the stock breather??

 

[Phill2]

I bought the ff kit with the breather ? mmmm eh ??? think it was a waste of good $$$? still leaks like an old whore? also use thin wall hose ?‍

I used thicker wall 6mm hose.
Hard to get in but no leaks.

 

[mark35]

Blocked the fuel cap hole? maybe I should change the breather?‍??

RFX Shorty One Way Valve Cap Fuel Vent Tubes from Dirtbikebitz https://swky.co/qUS23h
??

 

[21bangbang]

Ive considered these, but do I need more flow on my lil 29cc? I assume not, never seemed to have a fuel delivery issue.?‍ am I missing the point of these kits?

 

[Seandonato73]

Nope. Not needed thats the point

 

[evssv]

RFX Shorty One Way Valve Cap Fuel Vent Tubes from Dirtbikebitz https://swky.co/qUS23h
??

?...thk im gonna replace me shite snappy one ☹with one of these?

 

[Seandonato73]

I actually haven't had an issue with the snappy vent leaking....

 

[evssv]

I actually haven't had an issue with the snappy vent leaking....

mine semms to piss out ☹

 

[Seandonato73]

Yes, I've heard that... idk must have got a good one ?‍

 

[evssv]

makes everything feking wet n messy ffs??

 

[crucialRC]

I have the snappy kit on my baja, the breather supplied with the kit leaked all over the place so i changed it for an rfx dirt bike one and all is good.
Also be sure to block the stock breather??

Why the need to block the stock one?

 

[mark35]

Why the need to block the stock one?

one let's air in whilst fuel pisses out the other??

 

[crucialRC]

one let's air in whilst fuel pisses out the other??

Really? I would've that its always a vacuum, pulling air in.

 

[Seandonato73]

Too many holes mate, little sucker. Not enough with both breathers

 

[Phill2]

one let's air in whilst fuel pisses out the other??

I haven't blocked mine and never had a problem?

 

[siblues]

Stupid question from me.Why not use the barbed fittings with the stock cap and bigger lines.I would think that would ensure a tight fit and no leaking.

 

[21bangbang]

one let's air in whilst fuel pisses out the other??

Hey, I didn't say that?

 

[G-Man]

The Snappy vent never made any sense to me. Always seemed like a solution looking for a problem. But I've also never had a single issue with the cap vent doing its job. I've also never seen any issue with fuel delivery using the 3/16"x1/8" fuel lines, but I can see some utility with the FFRC kit. I suppose if I ever feel that my engine is starved, they will make it into ye ole shopping cart.

I used the FF kit because my fuel hoses were being crushed by the tank plug holes. What is funny. I have the 3 hole snappy tank plug too. The FF fittings were loose in those holes too. The fuel hose on the fittings then into the tank Plug worked. It ran very well today.

 

[DougStar]

Sweet so no leaks?‍ normally i fill my tank at home then load up? and its with the full tank as i lift the rear i get fuel pissing out the breather?

 

[mark35]

Hey, I didn't say that?

NO.. I did?