josegarcia8578
Well-Known Member
- Messages
- 92
- Location
- San Diego, CA
G320RC Pinion Gear Movement
- Thread starter josegarcia8578
- Start date
This site may earn a commission from merchant affiliate
links, including eBay, Amazon, and others.
links, including eBay, Amazon, and others.
josegarcia8578
Well-Known Member
- Messages
- 92
- Location
- San Diego, CA
- Thread starter
- #22
I found the issue! Mystery solve guys, @Cupton79 and @dougstar!
Bearings are good, bolt is correct size. However when the assembled at the factory, they did not match the slot on the pinion gear and the slot on the clutch bell. The slot and insert were perpendicular, you can see the mark on the pinion:
Now that I've matched the slots it fits like a glove. Thanks for the help guys! Really appreciate it!
Bearings are good, bolt is correct size. However when the assembled at the factory, they did not match the slot on the pinion gear and the slot on the clutch bell. The slot and insert were perpendicular, you can see the mark on the pinion:
Now that I've matched the slots it fits like a glove. Thanks for the help guys! Really appreciate it!
Attachments
- Messages
- 17,175
- Location
- Crafers South Australia
Easy fix well done?
It's a pleasure ??
It's a pleasure ??
- Messages
- 287
Anytime! That’s what we’re here for! ?
- Messages
- 8,911
- Location
- Flintshire,North Wales
Seen that a few times on the HPI Baja's.
J
J
- Messages
- 13,105
Another good reason to go over new machines. Glad you caught it before it broke.