head gasket!!!!

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, and others.
parts

alfred e numan said:
never ran that engine. the blown gasket- this a 2 bolt motor? if it is- try a ddm stainless steel graphite gasket- trim it so it drops easly on the jug, buy several of these-some have a better graphite coating than others- this is a must- hpi#15438. wide cap head torx screws 4 to a package- m5x20mm. take it down to 8n/m- heat cycle the car on the stand- retorque -repeat this 3 times- you work on bikes ect- you know about break loose torque- take it down to 9 n/m. no washers on the bolts-no loktite. yea, clean the mating surfaces with acetone- or touline- not the gasket before assembly- i have gallons of fuel tru this- wayy over heated- ran the crap outta the engine- not even a damp spot so far-- so far-lol!
Click to expand...
Hello, can you please describe what some of the parts from ddm are, I tried punching in the numbers listed here, but nothing comes up. Thanks Pete
 
Back
Top