PHillary
Active Member
Is it possible to install the ignition coil wire with the engine attached to the car or it must come out? 23cc DBXL
In car ignition install???
- Thread starter PHillary
- Start date
This site may earn a commission from merchant affiliate
links, including eBay, Amazon, and others.
links, including eBay, Amazon, and others.
cbaker65
Well Known Member
- Messages
- 2,710
- Reaction score
- 4,599
Id be worried about getting dirt in the crankcase
.......llke i would have cleaned it first at the least?
.......llke i would have cleaned it first at the least?
cbaker65
Well Known Member
- Messages
- 2,710
- Reaction score
- 4,599
Id be worried about getting dirt in the crankcase
LOL...not this junk I AM NOT!
Ok....... your rig I guess?
cbaker65
Well Known Member
- Messages
- 2,710
- Reaction score
- 4,599
I was experimenting with the engine ,so I am not too worried about it ,I was careful not to let debri fall in though!
If the engine was a high PO. ,sure ,it would be out an on the dinner plate!
- Messages
- 13,208
- Reaction score
- 22,962
If it's in the dbxl In your sig it's not a lot of work to pull it. And I don't think you can get the pull start off with out pulling it anyway. And that needs to come off to replace the ignition wire.