Killer ride

[maddmike]

I got my mt 3 weeks ago I still have yet to run it yet but still working very hard to get it flawless. So far I have done--------


Craftwerks plug wire


Outwears filters=pullstart and aif filter


team phat dad inclined shredstack


Baja air filter


Dominator pipe


Dyed fuel tank and gear cover blue


Snappy grommet with kraken vent


hitec 5645 throttle/brake


2x Hitec 5755 steering


ddm alloy servo arms (steering)


bad horsie shock covers


hpi 8,000 rpm spring


spektrum dx2s radio w reciever


Still waiting on ddm to get the v-2s killer bee in stock


I will post pics once i set up a photobucket account!!!


I am working on an xt as well that i just purchased a week after and well its the third week and ordered the dune runner yesterday. Think i got to much to work on haha well its winter here and got taxes back and Always a huge fan of hpi savages well have 3 and I wanted something big. my buddy ordered the baja so i ordered the dune runner cant wait to show him up with 4wd

 

[maddmike]

Heres some things I got done yesterday

 

[maddmike]

Hope this image works

 

[REVOlutionary Rampage]

Your pics aren't working but by the list of stuff you have on your MT, It sounds like its pretty bulletproof.

 

[Caveman80]

Can't wait to see pics sounds great

 

[Deluge1]

Hope this image works

Fixed. Nice MT!

 

[maddmike]

here is my modded roll cage to fit my craftwerks wire.

 

[Caveman80]

Looks sick. What did you use to color your gear cover?

 

[maddmike]

Here is my new 5645 throttle servo with 2 hitec 5755 with ddm alloy arms to turn them big wheels

 

[maddmike]

and here is the inclined shredstack

 

[maddmike]

I used blue rite dye from walmart i did it cause i already had a pot brewing with my tank in it!! I never tried it before but it all turned out really good

 

[Caveman80]

Ok have some down time maybe ill give it a try. So boil water add dye and submerge cover?

 

[maddmike]

ya i covered and make sure it is completely submerged low boil. I boiled it and turned it off and let it sit and then boiled it again i did that alot haha but turned out really good took like 8 hours

 

[maddmike]

here is my reciever box do you guys got any ideas of how to make the connector protected so it don't rust and get ruined i plan on using sealant or epoxy to seal the hole where the wire comes through

 

[Ludabud]

where did you get those servo horns?

 

[GTS 666]

Nice truck great job.

 

[maddmike]

those are ddm servo arms 10 bucks I didnt think that was bad at all very good and alot easier to get on then plastic

 

[Ludabud]

yea that is a pretty good deal. way better then those plastic ones.

 

[Deluge1]

here is my reciever box do you guys got any ideas of how to make the connector protected so it don't rust and get ruined i plan on using sealant or epoxy to seal the hole where the wire comes through

Wrap it with a balloon and secure it with a rubber band or a zip tie.

 

[maddmike]

thanks deluge you sure are a big help I don't know how i did not think of that!!! I need to do reciever yet also