Kv3359 center drive pin

[Braap2smoke]

Does any fellow 1/5 scalers have a spare pin willing to sell? Mine backed out and i hit up steve at ddm but he is lagging on getting it on his site. Said it was a new part and it was gonna take him a few days to get on the site but its now been over a week. I will definitely be putting some shrink wrap over it to prevent it from happening again. Thanks in advance.

 

[Seandonato73]

Go buy a drill bit the right size and cut the round end off it. Works in a pinch and should last for a while

 

[niz55]

Which exact pin are we talking here?

 

[Rep732]

I would take it he's looking for the center dog bone pins

 

[Braap2smoke]

Im terrible with component names
Sorry. Was not clear but this is for the kraken TT . The kraken vekta is a different pin.

 

[niz55]

https://www.davesmotors.com/KV9913

This is the new style and is much better. Has more threads and screw goes from the other side to secure it. Make sure to clean the threads on the pin, screw and the coupler threads with alcohol and wire brush and apply red locktite.

 

[Braap2smoke]

Thx Niz. I don't believe these are the same lengths as whats in the TT. I compared both from my manuals on the TT and vekta. If you know these will work i will order them.

 

[niz55]

Pretty sure it will fit.

My vekta.5 came with the same ones on your car the smaller ones and I got the new pins and worked perfectly.

https://www.largescaleforums.com/threads/new-pins.26959/

 

[Braap2smoke]

Thx for the help

 

[capflya]

Thx for the help

Assuming you found them by now? Just checking... if not I'm 99% sure I have some and I'm also in the bay area.

 

[Braap2smoke]

Assuming you found them by now? Just checking... if not I'm 99% sure I have some and I'm also in the bay area.

Ive got them ordered up and installed. Thx brotha. Ddm has them under a whole new part number than anything listed in the manual.