Maverick Blackout belt drive system

[Bad1/rampage]

Can I ask everyone what is the best gas mixing to use I've hear many many different mixs lol but after break in , when in the engine idles it sounds great but when I try to take off it takes a min to clear out then it runs fine,

 

[Phill2]

Any dirt bike oil is fine.
I use 27.5:1.
Sounds like your LSN is too rich.
Try leaning it a little at a time.

 

[Bad1/rampage]

25to1 is what I've been doing but people say you want just a little smoke not alot, but mine smoke like crazy and I have the carb needles set to factory,

 

[Phill2]

Factory settings are just a starting point to get it going.
Now it's time to tune it for running.
If you have too much smoke you're running rich and need to turn the LSN clockwise.
As you lean it the idle will increase so you may need to adjust the idle screw as well.
Use small adjustments 1/16 of a turn at a time.
You should see a little smoke so you know you're getting oil to the motor but not a lot.
25:1 is fine.

 

[Bad1/rampage]

Ok thanks I new it was smoking way to much so I just stop running it,

 

[Dansyco]

I agree with Phil. LSN give it 1/8-1/4 turn clockwise.

 

[Bad1/rampage]

Is there a kit that you can get for the 32cc engine,

 

[Dansyco]

Is there a kit that you can get for the 32cc engine,

What do you mean kit? Not sure what your looking for.

 

[Bad1/rampage]

I seen that there is a kit that you can buy for some engines but didn't know if there was for the stock engine to make more power out of the stock like this pic

 

[Phill2]

I seen that there is a kit that you can buy for some engines but didn't know if there was for the stock engine to make more power out of the stock like this pic

What engine have you got now?
Do you have a tuned pipe?

 

[Bad1/rampage]

The redcat tuned pipe

 

[Phill2]

The redcat tuned pipe

The alloy one?
That won't last long or perform very well.
Get a Jetpro and tune the engine you've got.

 

[Bad1/rampage]

Got my belt drive on, can't wait to see how it does.

 

[Phill2]

Got my belt drive on, can't wait to see how it does.

Great stuff
Did you shim the bottom 2 shafts so everything lines up and the belt stays straight??

 

[Bad1/rampage]

I didn't shim them it look pretty straight but I will look at it before trying it out when weather clears up, I installed new super bee kill switch also took the Dynamite kill switch out, it was working fine but hear a lot of bad things about it

 

[Phill2]

Just turn the clutch bell pulley by hand and make sure the belt stays straight