Hi,
It was first run of my MT.
Following modification was done:
1. wr-668 carb
2. CPI tuned pipe,
3. changed all bearings(fasteddy),
4. changed diff fluid 10k front, 5k rear
5. installed diff out-drive cups , maiden by local lathe master
6. hostile black boot, bought 12, but install only 4 , it works after cup installed.
without cup little bit larger.
I have not damaged anything and think power and speed is enough.
I like stock steering servo strength and don't understand why you are changing with hitec, futaba, etc..
As i am told newer servos come with better quality, hope mine last long enough.
Have to change spark plug with NGK CMR7H, also thinking power starter by killerrc.
It was first run of my MT.
Following modification was done:
1. wr-668 carb
2. CPI tuned pipe,
3. changed all bearings(fasteddy),
4. changed diff fluid 10k front, 5k rear
5. installed diff out-drive cups , maiden by local lathe master
6. hostile black boot, bought 12, but install only 4 , it works after cup installed.
without cup little bit larger.
I have not damaged anything and think power and speed is enough.
I like stock steering servo strength and don't understand why you are changing with hitec, futaba, etc..
As i am told newer servos come with better quality, hope mine last long enough.
Have to change spark plug with NGK CMR7H, also thinking power starter by killerrc.