Need help finding silicone pipe

[Z.hb71]

Help!!!!! Need a reducer pipe, it can be silicone or rubber. It needd to go from a 47MM inner diameter to a 47mm Outer diameter. It can be straight or up to a 45° Angle, can be any length becuase I can cut it, but just a fyi, I'm going to cut it to 9-10 inch length. I'm using it to relocate my air filter becuase my pipe will hit it. Also need to be under $15 bucks.

 

[DougStar]

I bought silicone hose from a 1/1 car turbo shop they had all sorts of hose bends ect. Look around
I only bought straight coz that's what I needed??

 

[Z.hb71]

I bought silicone hose from a 1/1 car turbo shop they had all sorts of hose bends ect. Look around View attachment 51205
I only bought straight coz that's what I needed??

ok.

 

[DougStar]

I used on my bart pipe as a coupler

 

[Z.hb71]

I used on my bart pipe as a coupler

i noticed i think i could use a 2 in straight 1 if the id is right cuz i can stretch my filter a little

 

[DougStar]

It was a hell of a job getting this stretched onto the bart ?
Once on it fitted like a glove. Sure you can make a plan? have you got a heart gun?

 

[Z.hb71]

Once on it fitted like a glove. Sure you can make a plan? have you got a heart gun?

no but ive got a blow dryer ?

 

[DougStar]

no but ive got a blow dryer ?

As long as you look good while you doing it???
Lol might work???

 

[Z.hb71]

As long as you look good while you doing it???
Lol might work???

i mean it gets fairly hot so maybe it could work

 

[DougStar]

On the air filter plastic yes ??

 

[Z.hb71]

On the air filter plastic yes ??

could i use a lighter on the silicone? far enough away for it not to melt it obvs

 

[DougStar]

What iv done in the past to put gas hoses on my torch boiling water place the hose in and it gets nice and soft

 

[Z.hb71]

What iv done in the past to put gas hoses on my torch boiling water place the hose in and it gets nice and soft

ok so that sounds like the best method for me

 

[Darnell]

Help!!!!! Need a reducer pipe, it can be silicone or rubber. It needd to go from a 47MM inner diameter to a 47mm Outer diameter. It can be straight or up to a 45° Angle, can be any length becuase I can cut it, but just a fyi, I'm going to cut it to 9-10 inch length. I'm using it to relocate my air filter becuase my pipe will hit it. Also need to be under $15 bucks.

Dirt bike shop, plumbing supply place?