Need help MT won't move!!!

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, and others.
X

XDEEDUBBX

Senior Member
Messages
352
Reaction score
1
Location
Los Angeles Ca.
Hey guys, I seem to have run into some problem with my MT. Everything start up fine but when I throttle the truck it doesn't move very far but the motor revs freely. If I throttle the motor it'll move a few inches and rev freely but it's not going anywhere. I'll post up a video tomorrow morning but any suggestions will help. Thanks


Bryan:( :( :(
 
The MT has pins that hold the gear mounts, if you have the 4pin style gears. They are behind the gears. You might have lost or broke one. This would allow a shaft to spin freely inside a gear.
 
cordy said:
Check the set screws on your drive cups.
Click to expand...
Like Cordy said... it could be one of your cups have a loose set screw resulting in no power to wheels. Check all your cup to see if they don't spin freely. Check if clutch is engaging?
 
Last edited by a moderator:
Looks like your brakes are dragging. Your throttle/brake linkages might need to be adjusted, or you need to adjust the brake screws.

Here's a visual...

205wnwl.webp
 
Thanks for posting that pic Deluge. I was looking at those screws today but never thought for a minute what they were for....

Is there a better diagram for the Rampage besides the one available at Redcat's site? Even at full zoom, it leaves a lot to be desired for....

My MT came with no CD. Was that only available on the first version?
 
Back
Top