rx lipo?

[rcpython59]

i got a 3200 2s lipo battery and i want to use it as a rx battery,will it fit,will it work,will i have to buy a lvd system? on a km ksrc-002 buggy

 

[atom3624]

Simple answer is YES and NO!!
Check that your Rx and servos can take the higher voltage of 2S LiPo.

If they can't it's no problem.
Get a 6V voltage regulator. LRP do a 6V / 10A regulator.

Not cheap, but could save you quite a lot of money!!!!

Al.

 

[Trebor]

i got a 3200 2s lipo battery and i want to use it as a rx battery,will it fit,will it work,will i have to buy a lvd system? on a km ksrc-002 buggy

why bother as atom says works out expensive,its touch and go with

the 6volt receiver batteries as it is, when fully charged can get to 7 volts

K....

 

[atom3624]

If you really want 'modern battery technology' then LiFe batteries are 6.6V, which would probably be OK without the regulator ...... (anyone know for certain?)

Al.

 

[Killer RC]

I don't run regulators. I use a Killer RC 7200mAh 7.4v LiPo with 6v servos. No problems.

 

[rcpython59]

so 2s is safe?i will get a buzzer then for like 5 bucks off ebay.does anyone know if a dynamite 3200 mah 2s will fit in the km rx tray?

 

[atom3624]

NO !!!!!!!!!!!!!!

Some servos don't have a problem.
Some servos have a MAJOR problem.

Check your manufacturer's recommended maximum voltages before you connect - it might be for the last time.

I have Rhinos on my vehicles, and there are plenty of stories of incompatibility with the higher 2S LiPo voltages with these.

Al.

 

[Killer RC]

Eh except for Rhinos, which aren't manufactured anymore.