Can anyone point me in the right direction of getting this killswitch in, long lead to engine, brown+red+yellow to channel 3, what’s the last connector at the bottom about? No mention of it in the instructions
Switchblade v2 install
- Thread starter Lopes3d
- Start date
This site may earn a commission from merchant affiliate
links, including eBay, Amazon, and others.
links, including eBay, Amazon, and others.
Can anyone point me in the right direction of getting this killswitch in, long lead to engine, brown+red+yellow to channel 3, what’s the last connector at the bottom about? No mention of it in the instructions
That lead looks like it gets direct power.
i just had a lookon rcmodelz mate, looks like you have a v2 switch,
it says on there that it has a 2amp auxiliary output,
v1 doesn't have that extra output,
i assume its so you can run a light controller or extra lights or something like that from it ,
not 100% sure though, probably just a case of tape it up and connect the rest as you would a v1,
it says on there that it has a 2amp auxiliary output,
v1 doesn't have that extra output,
i assume its so you can run a light controller or extra lights or something like that from it ,
not 100% sure though, probably just a case of tape it up and connect the rest as you would a v1,
- Thread starter
- #4
I’ll give that a go, need to get some right angled crimps or try and find my soldering iron. Instructions they sent me were for a v1 lol
i tried looking for the v2 instructions, but seems to be a secret mate
- Thread starter
- #6
Seems to bei tried looking for the v2 instructions, but seems to be a secret mate
. I’ll give that a crack see what happens