I shoulda done this years ago, but better late than never.
This is a machined Delrin battery box lid that's taller than the factory lid. It's totally sealed up. I wanted it to have no openings, to keep out dirt and water. You can easily drill holes in the sides or top to add lights, power switch, or whatever you want.
Delrin costs as much as aluminum, so these are kinda pricey to machine. Retail would be around $50
If there is enough interest, in 4-6 months I can have them injection molded, which would make them a lot cheaper, around $20, but I'd have to be able to sell at least 1000 of them to pay for the cost of the injection mold.
Whatcha think?
This is a machined Delrin battery box lid that's taller than the factory lid. It's totally sealed up. I wanted it to have no openings, to keep out dirt and water. You can easily drill holes in the sides or top to add lights, power switch, or whatever you want.
Delrin costs as much as aluminum, so these are kinda pricey to machine. Retail would be around $50
If there is enough interest, in 4-6 months I can have them injection molded, which would make them a lot cheaper, around $20, but I'd have to be able to sell at least 1000 of them to pay for the cost of the injection mold.
Whatcha think?
Last edited: