Throttle linkage.

[dirby]

ok so what is everybody using for Throttle linkage on there losi 5t?
I tried the quick release but the nut and washer holding the ball on vibrated loose and got lost.

 

[DougStar]

im using the stock linkage ....when i need to get in there i undo the screw on the carb done

nut and washer holding the ball on vibrated loose and got los

that sux ....loctite

 

[evssv]

I use ddm pro one but I put tiny bit of t.lock on the ball bit`s thread an its fine..

 

[Losi125]

Stock

 

[Whoduh]

I use ddm pro one but I put tiny bit of t.lock on the ball bit`s thread an its fine..

+1 on what he said.
I do the same thing.

 

[dirby]

I got the pro one and the nut and washer came off.
I got some more nuts and washer .I put one nut on woth red Loctite than put the second nut on and red loctited it too.don't think these nuts will be coming off anytime soon.

 

[DougStar]

red blue would have done the job..........hope it does not need to come off soon

 

[dirby]

there is always the Dremel tool.

 

[DougStar]

And a replacement linkage after

 

[evssv]

there is always the Dremel tool.

Awseome tool

red blue would have done the job..........hope it does not need to come off soon

U can jus take off the throttle plate and heat it up....and off comes the red t.lock...job done