atom3624
Well-Known Member
I've a FG Monster with normal G260RC to which I've fitted a DDM high end Dominator and a K&N type air filter.
With the 603 is was fine on 1.25 ish, 1.35 ish for the Low and High needle settings, but with the 813 I seem to have to set lower to lower the smokey exhaust, and limit the popping. 1.2, 1.2 seems fine.
Is this typical?
Are the 813 needles larger - excuse my ignorance? !!
The engine's running VERY well. Can't stop the wheels spinning, particularly in the wet, on tarmac, and grass. I'll get used to 'large 2WD' I suppose!!
I've read a previous post of setting carburettors, by warming up, setting low, then setting high when holding, aiming for maximum revs., not prolonged, then unscrewing a little. I think I'm still on the rich side, but DO NOT want to blow the engine, so didn't do too much of the high end setting up!!
With the 603 is was fine on 1.25 ish, 1.35 ish for the Low and High needle settings, but with the 813 I seem to have to set lower to lower the smokey exhaust, and limit the popping. 1.2, 1.2 seems fine.
Is this typical?
Are the 813 needles larger - excuse my ignorance? !!
The engine's running VERY well. Can't stop the wheels spinning, particularly in the wet, on tarmac, and grass. I'll get used to 'large 2WD' I suppose!!
I've read a previous post of setting carburettors, by warming up, setting low, then setting high when holding, aiming for maximum revs., not prolonged, then unscrewing a little. I think I'm still on the rich side, but DO NOT want to blow the engine, so didn't do too much of the high end setting up!!