Finally, looks pretty good
What did the postman bring you today?
- Thread starter evssv
- Start date
This site may earn a commission from merchant affiliate
links, including eBay, Amazon, and others.
links, including eBay, Amazon, and others.
Last few bits I am going to get for a while.
Man today must be my day look what showed up the last minute
Not much but much needed 
Markcarr
Well-Known Member
- Messages
- 19,475
- Reaction score
- 27,691
Better stop talking poop or they will dump your package in a swamp ?
- Messages
- 1,815
- Reaction score
- 3,260
Is that for your 55..I do have to admit these exhausts should have been a lead dougnut on the header with a cupped pipe end and 4 springs, so the pipes can take the shock and have a bit more flexibility on the headside
Gonna grab 2 more exhaust springs for mine with a little more tension
I got the 65 but I'm stumped with this gasket does this mount not need a gasket. Because gasket doesn't fit behind it or through it
The center piece is flanged on the end and seats in motor
The center piece is flanged on the end and seats in motor
- Messages
- 13,208
- Reaction score
- 22,962
Should go in between the pipe and flange imo
doesn't fit over it
- Messages
- 13,208
- Reaction score
- 22,962
Well idk then, that would be the logical place for it in my mind, can you slide the pipe in the flange and the gasket over the back of the pipe to the flange ?
EDIT never mind you can visibly see the gasket is smaller then the pipe now that I look at it again. Thinking you got the wrong gasket mate.
EDIT never mind you can visibly see the gasket is smaller then the pipe now that I look at it again. Thinking you got the wrong gasket mate.
Only way to get it to slide over is to remove the metal enter
It was the only one on there website
It was the only one on there website
- Messages
- 13,208
- Reaction score
- 22,962
You can see the flanged end seated in the engine
Markcarr
Well-Known Member
Isn't the soft lead supposed to get crushed and make a seal??
- Messages
- 1,815
- Reaction score
- 3,260
You don't need gasket..that's why I questioned your gasket post
I think its sealed by the flanged head either way I still removed the metal center from the gasket
I kind of felt that way also but hated seeing that little gap behind the flange like something was missing
- Messages
- 1,815
- Reaction score
- 3,260
But I still think the design should have been made with dougnut that slips over that header snub..but I'm no engineer ?
Funny ol setup that??