So I recently bought a 5t and a dynamite kill switch to go with it. Everything works as it should when programmed to aux 3 the only thing is when I turn off the transmitter the engine stays running. I have an sr6200a receiver and a Dx6c transmitter. AVC is disabled, I tried reversing the channel, binding with switch in off, holding switch in off while binding, setting different end point, I even tried a different aux channel, all with no luck. I have been trying to figure out this out for a few days now any help is appreciated. Thanks!
Dynamite kill switch
- Thread starter Issac_
- Start date
This site may earn a commission from merchant affiliate
links, including eBay, Amazon, and others.
links, including eBay, Amazon, and others.
Does that transmitter have adjustable frame rate? The only problem I had with one of their kill switches (I installed four of them) was a frame rate setting on my Spektrum Transmitter. Actually not a switch problem but a setting issue. I switched the framerate and works perfect. It did take me some time to figure this out.
- Thread starter
- #4
I just looked at the manual. It also has 16.5ms. Just curious what framerate did you have to use to get it to work?
Honestly without looking I can't give you an answer. I could look later when I get home after work.
I think when I finally figured it out, I probably tried all of them. Will try to remember to check later tonight for you.
I think when I finally figured it out, I probably tried all of them. Will try to remember to check later tonight for you.
A kill switch will not work with a spektrum avc receiver, you must get a non avc receiver like an sr515. I've been here myself and consulted with horizon hobby, they also agreed that it will never work as they too tried it for themselves.
- Thread starter
- #8
Even if AVC is disabled? The specs for the kill switch itself said it would work as long as avc is disabled
Here is what I have. It is in a Losi 5T 2.0 with the receiver that came in the truck. I added the kill switch to that. No other changes.
Transmitter : Spektrum DX3R frame rate set at 16.5
Receiver : Spektrum® 6200A DSMR 6-Ch AVC Surface RX ( that was in the truck)
Seems to work fine.
Transmitter : Spektrum DX3R frame rate set at 16.5
Receiver : Spektrum® 6200A DSMR 6-Ch AVC Surface RX ( that was in the truck)
Seems to work fine.
For the life of me I could never get the killswitch to work with an avc receiver with avc off. So I just called it a loss and just went with the sr515. I'll play games for a little bit and then after that I'm done and just want it to work.
I have no clue on AVC , weather it is on or off I couldn't tell you. A lot of this new technology is not my best skillset so I just keep pushing buttons and if it doesn't work I go back and push more buttons.
. I was ready to just run it with no remote kill but finally won that battle. Don't want to even think about how long it took me to get it
- Thread starter
- #12
So I just looked at my manual it says my radio does have 16.5 framerate but I don’t have the option on the transmitter itself. It only has 11 and 22ms for some reason. Anyone know a fix for this?.
Turn your electronics on and pick up your RC. In your hands move your RC from left to right like it is a matchbox car. The front wheels will self correct even if AVC is very low.
If i recall you fly Helicopters. Same same with the tail autocorrecting.
I will have to look into it a little more. Right now, things here are in storage. Too cold to play with toys and not liking it.
And no helicopters here , I did fly planes but for lack of a better term " sucked" at it. LOL