Joek72
Active Member
- Messages
- 35
So I was going through clutches so I decided to do a little mod. The last picture is the piece that was cut out. It was very thin so I would assume it will hold up as far it strength. What do you guy think?
A little dremel work
- Thread starter Joek72
- Start date
This site may earn a commission from merchant affiliate
links, including eBay, Amazon, and others.
links, including eBay, Amazon, and others.
- Messages
- 17,175
- Location
- Crafers South Australia
Neat mod looks good 
- Messages
- 7,017
- Location
- Nj
I think it will hold up. If not its an excuse to get a billet one