- Messages
- 2,962
- Location
- Long Island, ny
- Thread starter
- #21
Haven't done much wrenching. Been working a lot and haven't really had the desire to wrench.
I got the rig a couple weeks back. Did a proper break down, clean up and started replacing some parts.
Heres what ive done so far
FS clutch
new 1107 carb
Killer rc kill-switch
Killer rc 6000mah lipo
Hitec 7955 throttle servo
GRP extra soft sport tires
The rig is basically ready to go just need a new exhaust coupler which is on the way. Then just waiting for the weather to get better.
Thinking about replacing the air box, body, removing the two speed and replacing all the plastic around the engine with aluminum bits. Probably a 27.5 obr piston port in this rigs future.
I got the rig a couple weeks back. Did a proper break down, clean up and started replacing some parts.
Heres what ive done so far
FS clutch
new 1107 carb
Killer rc kill-switch
Killer rc 6000mah lipo
Hitec 7955 throttle servo
GRP extra soft sport tires
The rig is basically ready to go just need a new exhaust coupler which is on the way. Then just waiting for the weather to get better.
Thinking about replacing the air box, body, removing the two speed and replacing all the plastic around the engine with aluminum bits. Probably a 27.5 obr piston port in this rigs future.