Sfordt
Member
Getting a battery, receiver, and MOD kill switch into this little battery box is a nightmare. Any suggestions? tricks?
Build 1 Vekta.5 Gas
- Thread starter Sfordt
- Start date
This site may earn a commission from merchant affiliate
links, including eBay, Amazon, and others.
links, including eBay, Amazon, and others.
Patience and care, or a smaller battery? What do you have as battery?
I have that one in mine, I have the kill two side taped to the ceiling of the box at the back, then I put in the battery, fold up the wiring over the battery in lenghts of the battery, then I just slide the receiver in the back end under the hole for the signal wire, then I route the servo and kill switchbwires into the notch, holding everything in I put on the cover, just makes it.
I did get a gen ace 3500mah 2s with my 5t, much tinner, but the 7000 will last weeks between charges
I did get a gen ace 3500mah 2s with my 5t, much tinner, but the 7000 will last weeks between charges
- Messages
- 1,815
- Reaction score
- 3,260
Not sure if fellow member @Haric on here is still making billet Kraken boxes, there is also Jonny crash racing.
Sfordt
Member
i remember there was a guy on here that made battery boxes. idk what ever happened to him or if he's still doing it
Haric was his name on here
- Messages
- 13,208
- Reaction score
- 22,962
Last I heard he was busy with family and real life.
Yea that box is wicked tight eh... I was going to design my own box but like Haric I really haven't had the time. If there is interest here though I can try an make it a point to come up with something. It would be 3d printed. Let me know.