Sooo I managed to damage the cylinder head where the spark plug threads into the engine. Im not quite sure how but i must have cross thread it when i last installed it because it was difficult to unscrew out. Once out, i noticed i could not fully thread a new spark plug back in there. It would only thread part of the way but it did not seem seat all the way down. It started and ran ok until i noticed some power loss and noticed that the engine was losing compression. This is an expensive engine too. Its an OBR 30.5 Reed Case engine. I dnt understand how the thread could have damaged so easily. Im careful when i thread the spark plug in. Anyways does anyone know if theres anyway to get this fixed or rethreaded?? It appears some of the thread on the cylinder head is gone.
Thanks
Thanks