Dynamite DYNE1240 killswitch
- Thread starter Rc stoner
- Start date
This site may earn a commission from merchant affiliate
links, including eBay, Amazon, and others.
links, including eBay, Amazon, and others.
Monstertrucker1995
Reading the Rules!
- Messages
- 20
- Reaction score
- 6
I like the killer rc. Much easer to set up.
What channel is your kill switch on... and @Monstertrucker1995 we work with what we have im glad you like your killer rc killswitch
Monstertrucker1995
Reading the Rules!
- Messages
- 20
- Reaction score
- 6
Any aux channel. If using 2 channel then you have to switch it 2 channel run a "Y' harness. With the flysky radio you may have to turn on the aux channel and set the travel. Travel should be 100-125% EPA. I have to do that with my Airtronics M11.
Was asking rc stoner. I know how they work
And I would assume the killswitch is on the 3rd channel in the reciever? Did you assign a switch to aux 3.
Are the low cut off tabs still on the killswitch pins? I know its a dumb question but do you have the kill switch lead on the reciever going the right way? Its not flipped is it?
And I assume when the radio system is on and the k/s is hooked up right the led light isn't lit? Also how long have you had the k/s and where did you buy it
Rc stoner
Active Member
- Messages
- 43
- Reaction score
- 25
- Thread starter
- #33
When I turn everything on it lights up red so I can start the buggy but my throttle and breaking is all messed up now
When transmitter is on channel 1 the car doesn't start but when started if I put transmitter onto channel 1 it just sets of on it own full revs killswitch doesn't work on channel 1
- Messages
- 13,208
- Reaction score
- 22,962
Should be on channel 3 mate.
Assign the aux channel to a button on the transmitter that the kill switch is plugged into on the receiver