fs racing 4x4

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, and others.
Both the 805 and the 5745 don't firt straight in i fitted 2 x 805 into my own MT and had to shave 1.5mm of each side of the radio tray. A customrer who bought 5745 from me along with a ruck saud he cut the posts off and drilled new holes to get a good fit.
The 805's i fitted have been fine no problems yet and the steeering is much better than the stock single GWS unit.
Sickboy did you go for the 30cc or the 26cc engine?
 
does the use of 2 servos remove alot of the play in the servo saver or should we look for a upgraded servo saver mabey MCDs???
 
hellya i think its a ? of puting a ring (washer) in between i think that will do mthe trick what do you think kooltoyz hellya or anybody els
 
Last edited:
PowerSlideRacing said:
Ya gota change the clutch bell, gearbox shaft, centre diff drive shafts and centre diff crownwheel if you want to use MCD gears.
Click to expand...

thanks for the info....so it might be cheaper to get some steel gears made up for the FS like I did with the hammer

Is there a ball park figure $$$ for the parts to change over? you supply a changeover kit?
 
Last edited:
hellya im in it for the lol mate not for the money but i think you could better get in touch with kooltoyz hes got parts i know he can get you sorted ok

oh ye lets see your picks then what have you done to it up to now
 
posts

hi all have you sean how many posts their has bean 233 not including this one and that for a clone got to be good :lol::clap:

sorry i had to say it
any way no servos yet from ddm so thats another day no playing with the mcd 4wd ops sorry :clown:
 
Hi, I got my FS racing 4x4 buggy 2 weeks ago. I got a new radio system, failsafe, GP290 engine (which created a lot of trouble). Then one of my rear shock started to leak..T.T after 5 minutes of slow running on grass. Any suggestion of better shocks that will have a direct fit? also, when I am doing the after run maintance for the GP290, the texture of the piston appears to be rough. Is that normal? or I just some how fiddlesticked up a brand new engine?
 
mmx3se said:
the texture of the piston appears to be rough. Is that normal? or I just some how fiddlesticked up a brand new engine?
Click to expand...

Are you talking about the rough look when you look in the plug hole? If so yes some look rough depending on the piston. If your talking about the sides, No it should not be rough that would be from something rubbing and scratching.:no:
 
Back
Top