HY vs Zenoah engine mount dimensions?

[Bizzer]

Apologies if this has been previously discussed but I’ve attempted searching this and haven’t had much luck. I am swapping out a 30 cc fuelie with a G320 RC. When I went to bolt the engine to the chassis plate I found the Zenoah engine mounts are approximately 1/8 to 1/4 wider apart.

Has anyone else come across this, or am I doing something wrong?I am hoping I can just switch out the fan shroud, if that will work? I’d prefer not to have to modify the chassis and do some garbage job of elongating the factory holes to make it work.

 

[DougStar]

What car are fitting it in ? a losi
Post up some pics

 

[Seandonato73]

Need the cy fan cover swapped over on most applications as we.

 

[Bizzer]

^^ awesome Sean that’s what I was thinking! Thank you.
Doug, it’s not a Losi, unfortunately just the Redcat Rampage. If I had of been smart I would’ve looked a little closer before I started installing the Zenoah. I was just being lazy and didn’t feel like pulling it back out if I didn’t have to.

Now I just have to extract the other bolt that snapped on the old cover! ?. Both of them stripped but was able to successfully extract one the other didn’t go as well.