- Messages
- 3,656
- Location
- florida
- Thread starter
- #141
I was fighting with it for a while tried put the brake disk before the 0 ring then after the 0 ring and it still didn't sit right. It's good now went back to the original. Wasted a bunch of time though will need to stop here for the nightYeah I fought with mine and just swapped orings..no harm..big oring tweaked the rotor outwards and made it not sit proper when tightening the pads screws
On the old shaft it did seem to hold the disc
This new setup oring supplied is just way too big